ZENTRIFIX KMH

Mineral-based corrosion protection and bonding coat used in concrete repair

Zentrifx KMH is a ready to use mineral based one component corrosion inhinitor and a bond coat. In addition to use as corrosion protection, the use of Zentrifix KMH improves the adhesion of the coarse repair mortar. In addition it is also a solvent free product

Before application of Zentrifix KMH, the surface must be moistened. It should be damp, but not saturated with water. Zentrifix KMH is a one-component product, which must be mixed with water. ZentrifixKMH is slowly added to the water while stirring continuously, until a homogenous lump free mixture is achieved.

Mixing takes about 5 minutes. Slowly rotating mixers are particularly suitable. The Ratio of Zentrifix KMH to water is as mentioned below:

100 pbw Zentrifix KMH & 20 –25 pbw water

Zentrifix KMH can be applied by brush. As corrosion protection, the homogeneously mixed material is applied to the prepared reinforcing steel with suitable brushes in two coats. Care must be taken that binding wires and also the areas between reinforcement and concrete are fully coated to ensure sufficient coat thicknesses.

As with other cementitious materials, the added water may be varied slightly depending upon consistency required. As bonding Coat, the homogeneously mixed material is carefully brushed into the pre-wetted surface. Short bristle brushes are recommended.The coarse repair mortar is then applied onto this fresh bond coat. 

Only so many surfaces should be prepared as can be worked “fresh-on-fresh”. MC-Bauchemie (India) Pvt. Ltd. Manufactures these products alongwith a host of other Construction Chemicals in technical and financial collaboration with MC-Bauchemie, Germany. MC-Bauchemie (India) Pvt. Ltd. isan ISO 9001: 2008 certified Company.